1. Remove the four rubber screw covers from encircled locations.
    • Remove the four rubber screw covers from encircled locations.

    • Using a #0 tri wing screwdriver, remove the screws previously hidden below the rubber covers.

    • If you have difficulties finding this screwdriver, it is commonly sold as a Nintendo Gameboy/Wii screwdriver.

    Kommentar hinzufügen

  2. Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.
    • Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.

    • Be mindful of location and magnitude of applied force, so as not to damage the case.

    Kommentar hinzufügen

    • Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.

    Kommentar hinzufügen

    • Use fingernails to pry off minor LCD mount, as shown.

    • Remove the minor LCD

    Kommentar hinzufügen

    • Unlock the LCD main board connectors shown in red boxes on the picture .

    • Use tweezers as necessary.

    Kommentar hinzufügen

    • Place finger nails on the connector tab as shown.

    • Lift the connector tab up.

    Kommentar hinzufügen

    • Pull/pivot the LCD main board as shown in order to remove.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein weiterer Nutzer hat diese Anleitung absolviert.

Van

Mitglied seit 24.06.2010

7 Reputation

8 Anleitungen geschrieben

Team

Cal Poly, Team 2-10, Johann Summer 2010 Mitglied von Cal Poly, Team 2-10, Johann Summer 2010

CPSU-JOHANN-R10S2G10

4 Mitglieder

20 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 1

Insgesamt: 1,730