Repariere deine Sachen Community Store

Disassembling Samsung HMX-W300

Geschrieben von: Robert (und 5 anderen Mitwirkenden)
  • Kommentare: 0
  • Favoriten: 0
  • Vollendete Reparaturen: 3

Schwierigkeitsgrad

Mittel

Schritte

5

Zeitaufwand

5 Minuten

Abschnitte

1

Kennzeichnungen

0

Einleitung

Shows how to open up the camera without damaging interior content.

Werkzeuge

Ersatzteile

Keine Ersatzteile angegeben.

  1. To remove the wristband of the device, grab the middle loop and pull. Pull the band through as shown in the picture. To remove the wristband of the device, grab the middle loop and pull. Pull the band through as shown in the picture. To remove the wristband of the device, grab the middle loop and pull. Pull the band through as shown in the picture.

    • To remove the wristband of the device, grab the middle loop and pull. Pull the band through as shown in the picture.

    Bearbeiten

  2. Remove all four Hex screws with a Hex 1.5 mm screwdriver. Remove all four Hex screws with a Hex 1.5 mm screwdriver.

    • Remove all four Hex screws with a Hex 1.5 mm screwdriver.

    Bearbeiten

  4. To remove the HDMI screw, open the HDMI door on the side. Remove the screw using a Phillip size 00. To remove the HDMI screw, open the HDMI door on the side. Remove the screw using a Phillip size 00. To remove the HDMI screw, open the HDMI door on the side. Remove the screw using a Phillip size 00.

    • To remove the HDMI screw, open the HDMI door on the side. Remove the screw using a Phillip size 00.

    Bearbeiten

  5. As shown in the picture, use the plastic opening tool on both sides on the device. Pry apart both parts. Do not pry apart the device too hard. There is a wire that attaches the front case with the rear case. Do not pry apart the device too hard. There is a wire that attaches the front case with the rear case.

    • As shown in the picture, use the plastic opening tool on both sides on the device. Pry apart both parts.

    • Do not pry apart the device too hard. There is a wire that attaches the front case with the rear case.

    Bearbeiten

  6. Pull the wire ribbon out with a pair of tweezers. Pull the wire ribbon out with a pair of tweezers. Pull the wire ribbon out with a pair of tweezers.

    • Pull the wire ribbon out with a pair of tweezers.

    Bearbeiten
Abschluss

To reassemble your device, follow these instructions in reverse order.

3 weitere Nutzer haben diese Anleitung absolviert.

Tinte & Feder

mit 5 anderen Mitwirkenden

Robert

Mitglied seit: 21.01.2015

966 Reputation

8 Anleitungen geschrieben

Auszeichnungen: 9

+ 6 mehr Auszeichnungen

Team

USF Tampa, Team 9-2, Blackwell Winter 2015 Mitglied von USF Tampa, Team 9-2, Blackwell Winter 2015

USFT-BLACKWELL-W15S9G2

4 Mitglieder

16 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzten 24 Stunden: 0

Letzten 7 Tage: 3

Letzten 30 Tage: 5

Insgesamt: 619