Einleitung

This is how you would remove the outer panels of the Sanyo VPC-T850. This step is required for any repairs or a tear down.

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Turn the camera off by pressing the small, square button embedded in the top rim of the camera.
    • Turn the camera off by pressing the small, square button embedded in the top rim of the camera.

    • Slide out and open the hatch located on the bottom-right side of the camera.

    • In the revealed compartment, move the small notch and push in on the battery to remove it.

    • During reassembly, there is an arrow on the battery indicating which way it goes in.

    Kommentar hinzufügen

  2. Using the Phillips #00  Screwdriver, remove the 8 screws located around the sides and bottom of the camera.
    • Using the Phillips #00 Screwdriver, remove the 8 screws located around the sides and bottom of the camera.

      • Look for the screwhead with the label PH00 on the side in the kit provided.

    • Be sure to save these screws in a secure area to ensure they are not lost.

    Kommentar hinzufügen

    • Using the spudger, slowly pry the rear panel away from the left side.

    • Be careful not to damage the three green cables as you remove the rear panel of the camera.

    Kommentar hinzufügen

  3. Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    Frohes Fest, frohes Tüfteln
    Pack's ein, pack's aus, pack's an: Erhalte 12 € Rabatt auf deinen Einkauf ab 50 € mit dem Code FIXMAS12
    • Using the Phillips #00 Screwdriver, remove the 8 black screws connecting the green keypad chip to the rear panel.

    • Do not put any excessive force on the green wires.

    Kommentar hinzufügen

    • Separate the rear panel from the rest of the camera assembly.

    Kommentar hinzufügen

    • Using the Phillips #00 Screwdriver, remove the 3 screws located across the top of the camera.

    Kommentar hinzufügen

    • Carefully pull off the side covers wrapped around the camera.

    Kommentar hinzufügen

    • Using the spudger, gently pry the front cover of the camera off.

    • As the front cover is fragile, it can easily break if not removed carefully.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Jonathan Yau

Mitglied seit 11.04.2010

26 Reputation

4 Anleitungen geschrieben

Team

Cal Poly, Team 27-95, Amido Spring 2010 Mitglied von Cal Poly, Team 27-95, Amido Spring 2010

CPSU-AMIDO-S10S27G95

4 Mitglieder

4 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 1,911