Disassembling Sony Ericsson QuickShare T630 Phone Enclosure

Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.

Einleitung

This guide acts as a prerequisite for the guides following it. This will show you how to disassemble to phone enclosure in order to access the internal components of the device.

Was du brauchst

Schritt 1 Sony Ericsson QuickShare T630 Phone Enclosure

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure, Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 1, Bild 1 von 1

Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

Übersetzen

Schritt 2

Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

Übersetzen

Schritt 3

Slide the battery upward to remove.

Übersetzen

Schritt 4

Remove the rubber plug located near the camera by gently prying upward with your fingers.
Gently lift the camera shield after removal of the rubber plug.

Übersetzen

Schritt 5

Pry the remaining panel to loosen its contact to the phone using a spudger.
Slide the panel upward to remove it completely.
These steps will require a slight appliance of force.

Übersetzen

Schritt 6

Slide the aerial upward to remove it.

Übersetzen

Schritt 7

Remove the four screws located at each corner of the device.

Übersetzen

Schritt 8

Gently lift and remove the front panel of the phone after removing the screws.

Übersetzen

Schritt 9

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 9, Bild 3 von 3

This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.
Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.
Gently pull the ribbon from the circuit.
Remove the now disconnected screen.

Übersetzen

Schritt 10

Disassembling Sony Ericsson QuickShare T630 Phone Enclosure: Schritt 10, Bild 3 von 3

Remove the keyboard by slowly pulling it away from the circuit board.
There are no direct connections between the keyboard and phone.
These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.