Ersatzteile

Kein Ersatzteil erforderlich.

Use a large plastic opening tool along the rear panel:
  • Use a large plastic opening tool along the rear panel:

    • There are 4 clips to release.

Kommentar hinzufügen

Slide the cover along the plastic frame.
  • Slide the cover along the plastic frame.

Kommentar hinzufügen

  • Slide off the largest plastic pieces.

Kommentar hinzufügen

  • Bend the second small plastic piece to release it from the rubber piece.

  • Now you can slide it out.

Kommentar hinzufügen

  • Slide out the hard drive as shown in the picture

  • Make sure to slide as shown or you may damage the USB bridge logic board.

Kommentar hinzufügen

  • Remove the 4 rubber piece from the plastic frame at each corner.

Kommentar hinzufügen

  • Remove the rubber piece from the SATA/USB bridge logic board.

Kommentar hinzufügen

  • Remove both screws holding the retaining plate and the hard drive.

  • Slide the retaining plate in order to disconnect the SATA connector.

Kommentar hinzufügen

  • Remove both screws holding the retaining plate with the logic board.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Gaetan

Mitglied seit 26.12.2012

9.300 Reputation

18 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 2

Letzte 30 Tage: 11

Insgesamt: 1,348