Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Remove the four Phillips head screws that fasten the motor hub to the tube adapter.
-
-
-
-
Using a flathead screwdriver, pry the bearing cap from the tube.
-
-
-
Move the hub to the edge of the shaft so it is flush, and tighten the set screw using a T5 screwdriver bit.
-
The hub should fit snugly on the shaft, unable to rotate freely.
-
Optional- Add a drop of thread locking liquid to permanently hold the set screw in place after tightening.
-
Fast fertig!
To reassemble your device, follow these instructions in reverse order.
Abschluss
To reassemble your device, follow these instructions in reverse order.
