Zum Hauptinhalt wechseln

Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.

DualShock 2 Wireless Controller Analog Stick Replacement

Was du brauchst

  1. DualShock 2 Wireless Controller Analog Stick Replacement, Analog Stick: Schritt 1, Bild 1 von 2 DualShock 2 Wireless Controller Analog Stick Replacement, Analog Stick: Schritt 1, Bild 2 von 2
    • Remove the battery cover by pressing down on the release tab.

    • Remove the batteries.

    • It may be useful to use a small object to prop the controller during this fix.

    • For your safety and for the safety of the device, never work on the controller while it is still powered.

  2. DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 2, Bild 1 von 2 DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 2, Bild 2 von 2
    • Remove the six 7.8 mm anchoring screws from the back casing of the controller using a Phillips #0 screwdriver.

  3. DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 3, Bild 1 von 2 DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 3, Bild 2 von 2
    • Pull apart the outer casing by hand, or by using a plastic opening tool, from the bottom of the controller.

    • Be mindful not to sever the connection between the battery pack attached to the back casing and the internal board

  4. DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 4, Bild 1 von 2 DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 4, Bild 2 von 2
    • Remove the two 6.1 mm screws holding the internal analog stick board and the front of the controller together.

  5. DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 5, Bild 1 von 2 DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 5, Bild 2 von 2
    • Lift the analog stick board away from the front of the controller.

    • Remove the detached or loose analog stick for realignment.

  6. DualShock 2 Wireless Controller Analog Stick Replacement: Schritt 6, Bild 1 von 1
    • Realign the analog stick by pushing the removed stick back into its chassis with focus on pushing it in at the new, desired resting angle. You should feel or hear a small click if done correctly.

    • The stick may not immediately click into place under the pressure. Instead of pushing harder, try rotating the stick 90 degrees and pushing down again.

Abschluss

To reassemble your device, follow these instructions in reverse order.

15 weitere Nutzer:innen haben diese Anleitung absolviert.

Team

Texas Tech, Team S1-G1, Rauch Summer 2017 Mitglied von Texas Tech, Team S1-G1, Rauch Summer 2017

TTU-RAUCH-SU17S1G1

2 Mitglieder

4 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 9

Letzte 7 Tage: 47

Letzte 30 Tage: 202

Insgesamt: 11,955