Repariere deine Sachen Community Store

DualShock 4 Battery Replacement

Einleitung

Use this guide to replace the 3.7 lithium-ion battery inside the DualShock 4.

Was du brauchst

  1. DualShock 4 Battery Replacement, Controller: Schritt 1, Bild 1 von 1

    • Using the Phillips #00 Screwdriver, remove the four 6.0 mm screws securing the rear cover to the controller.

    • Be careful loosening the screws, using the wrong sized screwdriver, or letting the screwdriver slip can permanently damage the screw heads, making removal extremely difficult.

    Übersetzen

  2. DualShock 4 Battery Replacement: Schritt 2, Bild 1 von 3 DualShock 4 Battery Replacement: Schritt 2, Bild 2 von 3 DualShock 4 Battery Replacement: Schritt 2, Bild 3 von 3

    • Four fragile plastic clips hold the casing together. You can see their locations more clearly in this guide.

    • The clips help hold the seams together. If you break these clips, the controller will still work.

    • Beginning with the left handle:

    • Pinch the left handle of the controller to introduce an opening.

    • Wedge a plastic opening tool into the opening and slide it up towards the joystick.

    • Pull down on tool to pry open the casing.

    • Repeat these steps for the right handle.

    Übersetzen

  4. DualShock 4 Battery Replacement: Schritt 3, Bild 1 von 3 DualShock 4 Battery Replacement: Schritt 3, Bild 2 von 3 DualShock 4 Battery Replacement: Schritt 3, Bild 3 von 3

    • Wedge a plastic opening tool into the case-splittings and pull down to crack open the casing near the following buttons:

    • Share button

    • Options button

    • Split the plastic covers of the controller apart, taking note that they will still be attached by circuit board ribbons.

    • Three small pieces are often released from the framework. To prevent loss, maintain a controlled work field.

    • 2 Trigger Springs

    • 1 Grey Reset Button Extension

    Übersetzen

  5. DualShock 4 Battery Replacement, Battery: Schritt 4, Bild 1 von 3 DualShock 4 Battery Replacement, Battery: Schritt 4, Bild 2 von 3 DualShock 4 Battery Replacement, Battery: Schritt 4, Bild 3 von 3

    • Detach the motherboard ribbon connecting the two sides of the controller by pulling it straight out with your fingers.

    • Note the orientation of the cable and make sure it faces the right way when you reconnect it.

    • After the two halves are separated, place the top of the controller off to the side.

    Übersetzen

  6. DualShock 4 Battery Replacement: Schritt 5, Bild 1 von 3 DualShock 4 Battery Replacement: Schritt 5, Bild 2 von 3 DualShock 4 Battery Replacement: Schritt 5, Bild 3 von 3

    • Using the blunt forceps, remove the battery plug by gently rocking the forceps side-by-side to loosen the plug.

    • After removal of the plug from the motherboard, the battery can be lifted off of the controller.

    • Hasty removal of the battery plug could warp the plastic grips of the plug.

    Übersetzen
Abschluss

To reassemble your device, follow these instructions in reverse order.

206 weitere Nutzer:innen haben diese Anleitung absolviert.

Autor:in

mit 6 anderen Mitwirkenden

Mark

Mitglied seit: 01/21/14

7.719 Reputation

7 Anleitungen geschrieben

Auszeichnungen: 17

+ 14 weitere Auszeichnungen

Team

Cal Poly, Team 6-21, Maness Winter 2014 Mitglied von Cal Poly, Team 6-21, Maness Winter 2014

CPSU-MANESS-W14S6G21

4 Mitglieder

40 Anleitungen geschrieben

29 Kommentare

My Dualshock 4 wont turn on after the battery replacement.

Any idea on why this happened?

Alexander - Antwort

have you tried to charge it?

Mohamed Aden -

I had a problem with my console but with your guide it is possible to solve this one I think.

Praska - Antwort

I found a replacement battery here, you have to mod the tray a little, but it works like a champ and doubles the life.

http://www.ebay.com/itm/PS4-Controller-B...

binazriel - Antwort

The x button on my controller want working properly so I ordered new rubber mounts. I followed the guide, taking my time to make sure I didn't damage anything.

With the new rubber in place I put everything back together and the controller was working fine but now I've realised it doesn't charge. The battery goes completely dead and switches off. If I then connect it with usb cable it doesn't charge but will turn on the controller for maybe 10 seconds before switching off again.

Anyone any idea what is going on? Thanks.

Kenny - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 76

Letzte 7 Tage: 700

Letzte 30 Tage: 3,155

Insgesamt: 371,750