Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
Follow this guide to replace a worn or damaged belt on the Edco Cement Saw KL1465H.
Was du brauchst
-
-
Disconnect the spark plug to prevent the engine from accidentally starting up during service:
-
Grab the plastic spark plug cap at the end of the spark plug wire.
-
Firmly pull to disconnect the spark plug cap from the spark plug.
-
-
-
To prevent the concrete saw from rolling during service, place wheel chocks in front of and behind a rear wheel.
-
-
-
Use a 3/8-inch wrench to remove the two bolts securing the arbor guard.
-
Remove the arbor guard.
-
-
-
Use a 3/8-inch wrench to remove the two bolts securing the belt guard.
-
Remove the belt guard.
-
-
-
-
Use a 9/16-inch wrench to loosen the lock nut on the engine's tap bolt.
-
-
-
Use a 9/16-inch wrench to loosen the engine's tap bolt until the tip of the bolt is about an inch away from the engine.
-
-
-
Use a 9/16-inch wrench to loosen the five engine mounting nuts on the front and back of the engine, but do not remove them.
-
-
-
Use a flathead screwdriver or a 3/8-inch wrench to remove the screw securing the drain hose to the concrete saw.
-
-
-
Slide the engine forward on the frame to relieve tension on the belts.
-
-
-
Remove the outer belt from the engine and arbor pulleys.
-
Repeat the process for the inner belt.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.
