Zum Hauptinhalt wechseln

Eureka 1660SP Roller Replacement

Was du brauchst

  1. Eureka 1660SP Roller Replacement, Roller: Schritt 1, Bild 1 von 2 Eureka 1660SP Roller Replacement, Roller: Schritt 1, Bild 2 von 2
    • Press the black separator switch and lightly pull the bottom half away from the top.

  2. Eureka 1660SP Roller Replacement: Schritt 2, Bild 1 von 2 Eureka 1660SP Roller Replacement: Schritt 2, Bild 2 von 2
    • Remove the vacuum head from the lower half of the body.

  3. Eureka 1660SP Roller Replacement: Schritt 3, Bild 1 von 3 Eureka 1660SP Roller Replacement: Schritt 3, Bild 2 von 3 Eureka 1660SP Roller Replacement: Schritt 3, Bild 3 von 3
    • Turn the vacuum head wheels up and remove all seven 13.9mm screws from the bottom using a #2 Phillips head screwdriver.

    • Separate the top and bottom of the vacuum head. Set the top aside.

  4. Eureka 1660SP Roller Replacement: Schritt 4, Bild 1 von 2 Eureka 1660SP Roller Replacement: Schritt 4, Bild 2 von 2
    • Turn the vacuum head's bottom over so that the inside of the head is facing up.

    • Using a Phillips #00 screwdriver, press down on metal bar of the roller on one side until it releases from the housing.

    • Turn the vacuum head's bottom over and pull at the roller and bar until they are completely out of the housing.

  5. Eureka 1660SP Roller Replacement: Schritt 5, Bild 1 von 1
    • Press the new bar and roller into place.

    • Replace the screws.

Ziellinie

Team

UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013 Mitglied von UMass Dartmouth, Team 1-1, Gulbrandsen Fall 2013

UMASSD-GULBRANDSEN-F13S1G1

3 Mitglieder

12 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 434