Zum Hauptinhalt wechseln

Einleitung

If you determine that your vacuum is no longer picking up debris, is hard to push, or brush roll will not turn, this guide will help you to replace the belt.

Ersatzteile

Keine Ersatzteile angegeben.

  1. Step on the grey release button located between the two back wheels to lower the handle flat to the floor. Insure the vacuum is unplugged before starting the process of removing the brush roll.
    • Step on the grey release button located between the two back wheels to lower the handle flat to the floor.

    • Insure the vacuum is unplugged before starting the process of removing the brush roll.

  2. Using a Phillips #2 screwdriver, remove the four screws from each corner of the brush roll cover.
    • Using a Phillips #2 screwdriver, remove the four screws from each corner of the brush roll cover.

  3. Remove the brush cover from the vacuum base, by pulling straight up. Remove the brush cover from the vacuum base, by pulling straight up.
    • Remove the brush cover from the vacuum base, by pulling straight up.

  4. Firmly press upwards from below the brush roll on the side opposite the belt.
    • Firmly press upwards from below the brush roll on the side opposite the belt.

  5. After one end is displaced, remove the other side by pressing firmly upwards from below the the brush roll.
    • After one end is displaced, remove the other side by pressing firmly upwards from below the the brush roll.

  6. Once the brush roll is displaced from the base, detach the belt from the brush roll in order to clean the brush roll.
    • Once the brush roll is displaced from the base, detach the belt from the brush roll in order to clean the brush roll.

  7. Remove the belt from around the motor. Remove the belt from around the motor. Remove the belt from around the motor.
    • Remove the belt from around the motor.

Abschluss

To reassemble your device, follow these instructions in reverse order.

7 weitere Nutzer haben diese Anleitung absolviert.

Celina Burchett

Mitglied seit: 13.10.2014

1.101 Reputation

8 Anleitungen geschrieben

Team

Clemson, Team 2-2, Benson Fall 2014 Mitglied von Clemson, Team 2-2, Benson Fall 2014

CLEM-BENSON-F14S2G2

4 Mitglieder

8 Anleitungen geschrieben

It was Too hard So went to stretch the belt then it was on

missouri river production - Antwort

To reassemble was not available for me so I kind of did it myself but I'm having trouble getting it back on straight

eternallight6 - Antwort

i have read every sticker on this vbacuum read several maintenance steps …. i mean DA remove four screws …huh.

now can someone tell me whart size belt to get from the store

Sara Leinen

sparkplugkitten@msn.com

Sara Leinen - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 8

Letzte 7 Tage: 52

Letzte 30 Tage: 332

Insgesamt: 41,517