Ersatzteile

Kein Ersatzteil erforderlich.

Use the Phillips #00 screwdriver to remove the 7 screws on the sides of the camera: Four 3.95mm Phillips screws located on the bottom of the camera Two 3.95mm Phillips screws located on the right side of the camera
  • Use the Phillips #00 screwdriver to remove the 7 screws on the sides of the camera:

    • Four 3.95mm Phillips screws located on the bottom of the camera

    • Two 3.95mm Phillips screws located on the right side of the camera

    • One 3.95mm Phillips screw located on the left side of the camera

Kommentar hinzufügen

Slide open the battery compartment cover with your thumb.
  • Slide open the battery compartment cover with your thumb.

Kommentar hinzufügen

Wedge the edge of the spudger between the front and back case, near the corner of the flash. Carefully run the spudger along the right edge of the camera, creating an opening. Insert the spudger into the left side of the camera, above the screwhole. Then carefully run it along this edge.
  • Wedge the edge of the spudger between the front and back case, near the corner of the flash.

  • Carefully run the spudger along the right edge of the camera, creating an opening.

  • Insert the spudger into the left side of the camera, above the screwhole. Then carefully run it along this edge.

Kommentar hinzufügen

Watch out for the orange ribbon that is still attached to the back cover when you lift it up. It is very delicate and might rip. Slowly lift the back cover straight up, lightly jiggling it if necessary.
  • Watch out for the orange ribbon that is still attached to the back cover when you lift it up. It is very delicate and might rip.

  • Slowly lift the back cover straight up, lightly jiggling it if necessary.

  • Remove the battery compartment cover.

Kommentar hinzufügen

Gently insert the spudger under the clip holding the orange ribbon. The clip should lift up and the ribbon will slide out.
  • Gently insert the spudger under the clip holding the orange ribbon. The clip should lift up and the ribbon will slide out.

  • This step will free the back cover from the rest of the camera.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Sarthak Patel

Mitglied seit 03.04.2012

1 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team 14-8, Forte Spring 2012 Mitglied von Cal Poly, Team 14-8, Forte Spring 2012

CPSU-FORTE-S12S14G8

5 Mitglieder

8 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 779