Einleitung

Before starting this replacement, make sure you've read the troubleshooting guide to verify that the touchpad needs to be replaced. There are fragile ribbon connectors being removed in this guide, so proceed with caution!

  1. Use the iFixit opening tools or a metal spudger to pry the rubber covers off the back of your Pixelbook.
    • Use the iFixit opening tools or a metal spudger to pry the rubber covers off the back of your Pixelbook.

    • Peel the linings off completely until the back of the Pixelbook looks bare.

    Kommentar hinzufügen

  2. Remove the two yellow 2.0mm screws by using a T3 Torx screwdriver.
    • Remove the two yellow 2.0mm screws by using a T3 Torx screwdriver.

    Kommentar hinzufügen

    • Remove the seventeen 3.0mm T5 Torx screws from the bottom panel.

    Kommentar hinzufügen

    • Use the nylon spudger to pry the edge of the Pixelbook up until you can grab the edge with your fingers.

    • Open the back panel completely and lay it flat so you see the whole inside of the computer.

    Kommentar hinzufügen

    • Remove the yellow 2.0mm screw from the middle of the panel by using the T3 Torx screwdriver to turn the screw counterclockwise.

    Kommentar hinzufügen

    • Remove the small, black casing by using the spudger to lift it up from its place.

    Kommentar hinzufügen

    • Disconnect the flat, black cord from the main component by using a spudger to push it out of the slot, or by using your hand to carefully pull it out.

    • Your back panel is now free from the main component.

    Kommentar hinzufügen

    • Once the back panel is out of the way, use the T3 Torx screwdriver to turn both the 2.0mm and large 3.0mm gold screws from the touchpad.

    Kommentar hinzufügen

    • Gently pull out the ribbon connector either by using tweezers or your fingers to pull the cord out and up.

    Kommentar hinzufügen

    • Use the nylon spudger to push the touchpad out of the laptop by inserting the point into the hole near the edge of the laptop.

    • As the metal plates with the screws tilt upwards, use your hand to catch the falling touchpad and remove it.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Derrick Unger

Mitglied seit 24.01.2018

288 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team S18-G1, Livingston Winter 2018 Mitglied von Cal Poly, Team S18-G1, Livingston Winter 2018

CPSU-LIVINGSTON-W18S18G1

4 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 2

Letzte 7 Tage: 28

Letzte 30 Tage: 102

Insgesamt: 579