Grip Tape Application

Einleitung

If you have just bought your skateboard deck, strip the plastic from it and remove any stickers that are on the top of the deck where the grip tape will be applied. Be sure to have all of your tools and materials close by to make the installation process faster and more efficient.

Was du brauchst

Schritt 1 Grip Tape Application

Grip Tape Application, Grip Tape Application: Schritt 1, Bild 1 von 1

Peel off the paper backing from the sheet of grip tape.
Make sure you do not fold or wrinkle the grip tape.

Bearbeiten

Schritt 2

Center the sheet of grip tape evenly over the top of the skateboard deck.

Bearbeiten

Schritt 3

Starting from the very middle and moving outward, firmly press down on the grip tape while smoothing out any air bubbles that start to form.

Bearbeiten

Schritt 4

Use a screwdriver to scrape along the edges of the skateboard. This will remove some of the grip around the edges making the trimming process easier on you and your equipment.
You can use the utility knife to cut a perpendicular line in the excess grip tape if it is resisting the screwdriver too much.

Bearbeiten

Schritt 5

Grip Tape Application: Schritt 5, Bild 3 von 3

Use a utility knife to begin cutting around the edge of your skateboard to remove excess grip tape.
Angle your knife towards the inside of the skateboard to make it easier to cut a straight line.
Be careful when using the utility knife and always keep it pointed away from yourself and others.

Bearbeiten

Schritt 6

Once you have removed all of the excess grip tape, you can use the scraps to sand the edges of your cut to smooth out any small inconsistencies.
Use caution when sanding as the grip tape can become heated.

Bearbeiten

Schritt 7

If air bubbles persist, gently use a utility knife to poke a small hole in the grip tape at the center of the bubble and press out the air.
Be careful when using the utility knife and always keep it pointed away from yourself and others.

Bearbeiten