Zum Hauptinhalt wechseln

Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.

Was du brauchst

  1. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 1, Bild 1 von 2 : Schritt 1, Bild 2 von 2
    • Remove the two (9 mm) hand screws on the back panel.

  2. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 2, Bild 1 von 3 : Schritt 2, Bild 2 von 3 : Schritt 2, Bild 3 von 3
    • Place the tower on its side.

    • Slide the side panel horizontally to detach, and pull upward to remove.

  3. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 3, Bild 1 von 2 : Schritt 3, Bild 2 von 2
    • Orient the tower vertically.

    • Using the #0 Phillips head screwdriver, unscrew and remove the two (5 mm) screws that fasten the remaining side panel to the tower.

    • Slide the side panel out of its notches, and pull it gently off of the tower.

  4. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 4, Bild 1 von 1
    • Gently move the tower so that it is in the horizontal orientation.

    • Press down the black tabs (proximal to you) that fasten the front panel to the tower.

    • Press down on the distal, black tabs (symmetric with respect to the previous tabs).

    • Pull front panel forward slightly.

  5. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 5, Bild 1 von 2 : Schritt 5, Bild 2 von 2
    • Orient the tower vertically.

    • The front panel will come off in a hinge-like fashion, exposing the drives underneath.

Ziellinie

Team

Clemson, Team 6-1, Benson Spring 2014 Mitglied von Clemson, Team 6-1, Benson Spring 2014

CLEM-BENSON-S14S6G1

3 Mitglieder

15 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 403