Einleitung

Use this guide to replace the hard drive.

  1. With the case closed, place the Mini 1000 top-side down on a flat surface.
    • With the case closed, place the Mini 1000 top-side down on a flat surface.

    • Push both of the battery release latches toward each other.

    Kommentar hinzufügen

  2. Lift the battery out of the Mini 1000 from the edge closest to the release latches.
    • Lift the battery out of the Mini 1000 from the edge closest to the release latches.

    Kommentar hinzufügen

    • Remove the following two screws:

      • One 6 mm Phillips screw

      • One 4 mm Phillips screw

    Kommentar hinzufügen

    • To facilitate the removal of the keyboard, it is recommended to push the keyboard outwards with one hand through the opening (highlighted in the third picture) located on the backside of the Mini 1000.

    • While pushing through the opening with one hand, grasp the left upper edge with the other hand and slightly pull the keyboard towards you.

    • Once an opening has been established, grasp the keyboard and slowly lift it upwards along the upper perimeter of the top edge.

    Kommentar hinzufügen

    • Lift the keyboard out of the upper case, minding the cable that is still connecting it to the motherboard.

    Kommentar hinzufügen

    • Use your fingernail or the flat end of a spudger to flip up the retaining flap on the keyboard cable ZIF socket.

    • Be sure you are prying up on the retaining flap, not the socket itself.

    • Pull the cable out of its socket and remove the keyboard.

    Kommentar hinzufügen

    • Use your fingernail or the flat end of a spudger to flip up the retaining flap on the SIM card ribbon cable ZIF socket.

    • Be sure you are prying up on the retaining flap, not the socket itself.

    • Pull the SIM card ribbon cable out of its socket and peel it off the top of the hard drive enclosure.

    Kommentar hinzufügen

    • Use your fingernail or the flat end of a spudger to flip up the retaining flap on the hard drive cable ZIF socket.

    • Be sure you are prying up on the retaining flap, not the socket itself.

    Kommentar hinzufügen

    • Remove the two 4.5 mm Phillips screws securing the hard drive to the lower case.

    Kommentar hinzufügen

    • Lift the hard drive up and out of the lower case, being careful not to damage its cable in the process.

    Kommentar hinzufügen

    • Carefully peel up the two foam bumpers from the ends stuck to the bottom of the hard drive.

    • It is not necessary to peel these bumpers off the hard drive enclosure.

    Kommentar hinzufügen

    • Lift up the center retaining tab on the hard drive enclosure and simultaneously push the hard drive out through the open end of the enclosure.

    Kommentar hinzufügen

    • Use your fingernail or the flat end of a spudger to flip up the retaining flap on the hard drive cable ZIF socket.

    • Be sure you are prying up on the retaining flap, not the socket itself.

    • Pull the hard drive cable out of its socket.

    • Hard drive remains.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

17 weitere Nutzer haben diese Anleitung absolviert.

Great guild, straight forward and easy to follow. Take care disconnecting the hard drive. The clip slides slightly up and then turns up.

Mark - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 2

Letzte 7 Tage: 17

Letzte 30 Tage: 81

Insgesamt: 37,486