Einleitung

The HP Mini 110 comes stock with a 160GB hard disk drive. Whether it needs replacement due to failure, or it is desired to upgrade it to a larger size or replace it with a solid state drive, this guide is applicable.

Power-off the netbook fully before attempting to remove the battery.
  • Power-off the netbook fully before attempting to remove the battery.

  • Flip your netbook upside down, and locate the sliding tabs near the battery.

  • Slide both tabs inward so that the battery visibly moves away from the case of the computer.

  • Release the tabs and pull the battery out.

Kommentar hinzufügen

With the screen closed, turn your netbook around so that the battery slot is facing you.
  • With the screen closed, turn your netbook around so that the battery slot is facing you.

  • Remove the three 2.9mm screws in the battery slot.

    • This step can be made easier by using a magnetic screwdriver.

Kommentar hinzufügen

  • Flip the netbook upright, and open the screen as far as it will go.

  • Pry up the keyboard from the middle of the top edge.

    • Insert the flat end of the spudger between middle of the the top edge of the keyboard and the plastic frame behind it.

    • Pry the keyboard up until it pops out or until you can grab it with your fingers, and then pull gently until it pops out on both sides.

    • Do not pull the keyboard out immediately - there is a potentially fragile ribbon cable that attaches to the motherboard behind the keyboard.

Kommentar hinzufügen

  • Flip the keyboard over (toward you) by pivoting it about the lower edge, and lay it upside down on top of the touchpad area to reveal the ribbon cable.

  • Lightly pull up on the black tab on top of the keyboard ribbon cable until it hinges toward you and releases the ribbon cable end.

  • Pull the ribbon cable backward and out of the receptacle. This should not require any effort.

Kommentar hinzufügen

  • Remove the three screws holding down the hard drive. Use a Phillips PH0 screwdriver for the two silver, 3.4mm screws on the right, and use a PH1 for the black, 10.3mm screw on the left.

    • It is not necessary to fully remove the 10.3mm screw, but if you do, be careful to not lose the spring.

Kommentar hinzufügen

  • As shown on the top face of the hard drive itself, pull hard drive left using the black tab until the hard drive is unplugged and entirely released from its receptacle.

  • Lift the hard drive out of the laptop.

  • Place the hard drive in an anti-static bag to reduce the likelihood of damaging it with static electricity.

Kommentar hinzufügen

Abschluss

To install a new hard drive or re-install the old one, follow these instructions in reverse order.

6 weitere Nutzer haben diese Anleitung absolviert.

Amos Hine

Mitglied seit 18.10.2013

1.119 Reputation

7 Anleitungen geschrieben

Team

Clemson, Team 14-1, Benson Fall 2013 Mitglied von Clemson, Team 14-1, Benson Fall 2013

CLEM-BENSON-F13S14G1

3 Mitglieder

12 Anleitungen geschrieben

Appreciate the article well Done !!!

jpc6517 - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 4

Letzte 7 Tage: 35

Letzte 30 Tage: 116

Insgesamt: 16,188