Einleitung
Make sure the device is powered off and is not attached to any electronics.
Was du brauchst
-
-
Use the spudger to pry off the two rubber feet near the hinge of the laptop. This will reveal two hidden 9mm screws.
-
You must remove eleven screws.
-
Four 9mm screws with the PH0 screwdriver.
-
Seven 6mm screws with the PH0 screwdriver.
-
-
-
Use the spudger to pry the corners of the laptop near the display hinges.
-
Pry around the seam of the laptop with the plastic opening tool until the backing begins to pull apart.
-
-
-
Use the plastic opening tool to lift the white tab up at the connection.
-
Pull the cable outwards.
-
-
-
Use the spudger to pry up the blue/white speaker wires that are routed beside the battery.
-
-
-
Remove the battery cable from the motherboard by gently pulling out on the black part of the cable closest to the white tab.
-
-
-
Remove the battery.
I found the battery on Amazon
Könnten Sie mir bitte sagen, was für ein Akku verwendet worden ist.
das wäre für mich sehr hilfreich.
Vielen Dank
-
-
-
Use your fingernails to slowly loosen the fan connection cable.
-
After the cable is slightly pulled from the connection, grab the cable and pull it outwards.
-
-
-
-
Remove the three 3mm screws using the PH0 screwdriver.
-
Pull the hard drive slightly away from the connection to easily disconnect the hard drive cable from the motherboard.
-
Remove the hard drive.
-
-
-
Remove the two screws from the metal hinge on the power button side using the PH0 screwdriver.
-
One silver 4mm screw
-
One black 5mm screw
-
Lift up the hinge to remove the metal bracket underneath.
-
-
-
Remove one 3mm screw using the PH0 screwdriver from the metal hinge located on the power connector side of the computer.
-
Lift up the hinge with some force to remove the metal bracket underneath.
-
-
-
Unscrew the two 3mm screws with the PH0 screwdriver.
-
Pull the wireless card out of its port to disconnect it from the motherboard.
-
-
-
Push the black tab away from the hinge of the laptop.
-
After the black tab has been flipped, pull out the blue cable to disconnect the keyboard cable.
-
-
-
Pull horizontally toward the hinge of the laptop to disconnect the webcam cable.
-
-
-
Pull up on the black tabs to disconnect the display cable.
-
-
-
Pull the cable horizontally away from the motherboard to disconnect the power button board cable.
-
-
-
Pull the cable horizontally away from the motherboard to disconnect the power connector cable.
-
-
-
Pull the cable horizontally away from the motherboard to disconnect the speaker cable.
-
-
-
Push the white tab up toward the hinge of the laptop.
-
Disconnect touch pad cable by pulling up and away from the motherboard.
-
-
-
Remove the four 3mm screws using the PH0 screwdriver.
-
Lift up the heat sink to remove it from the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
10 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
Cal Poly, Team 19-9, Maness Winter 2015 Mitglied von Cal Poly, Team 19-9, Maness Winter 2015
CPSU-MANESS-W15S19G9
4 Mitglieder
12 Anleitungen geschrieben
