Einleitung

This guide will show you how to remove the fans.

Ersatzteile

Kein Ersatzteil erforderlich.

Begin by turning the laptop over so that you can see the bottom of the computer.
  • Begin by turning the laptop over so that you can see the bottom of the computer.

Kommentar hinzufügen

Slide the battery release switch to the right while simultaneously lifting up the battery.
  • Slide the battery release switch to the right while simultaneously lifting up the battery.

Kommentar hinzufügen

Loosen the 8 Phillips screws around the plate and remove the plate.
  • Loosen the 8 Phillips screws around the plate and remove the plate.

Kommentar hinzufügen

Remove the 9 Phillips screws from the plate covering the fans.
  • Remove the 9 Phillips screws from the plate covering the fans.

  • The 3 screws around the lower fan also hold the fan onto the metal plate.

Kommentar hinzufügen

Lift the plate and lower fan off the heat sink being careful not to damage the lower fan cable, which is attached to the motherboard.
  • Lift the plate and lower fan off the heat sink being careful not to damage the lower fan cable, which is attached to the motherboard.

  • Disconnect the lower fan connector from the motherboard.

  • Remove the metal plate and lower fan.

  • The lower fan will easily separate from the metal plate.

Kommentar hinzufügen

Disconnect the upper fan connector from the motherboard.
  • Disconnect the upper fan connector from the motherboard.

  • Remove the 4 spring loaded screws holding the heat sink assembly to the motherboard.

  • When reassembling, thread all screws in 1 - 1 1/2 turns then alternately tighten each screw 1 turn - starting top left, then bottom right, then bottom left, then top right, then top left again etc. until the heat sink assembly is firmly seated and all screws are tightened the same amount.

Kommentar hinzufügen

Slide the heat sink assembly including the upper fan out by pulling it down and left simultaneously.
  • Slide the heat sink assembly including the upper fan out by pulling it down and left simultaneously.

  • When reinstalling heat sink, ensure it is thoroughly cleaned and the thermal paste (or pads ) are replaced to ensure proper thermal contact with the devices on the logic board to prevent thermal issues.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

3 weitere Nutzer haben diese Anleitung absolviert.

Shantel

Mitglied seit 20.04.2010

470 Reputation

6 Anleitungen geschrieben

Team

Cal Poly, Team 30-37, Garner Spring 2010 Mitglied von Cal Poly, Team 30-37, Garner Spring 2010

CPSU-GARNER-S10S30G37

4 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 4

Insgesamt: 6,130