Einleitung

Replace the wireless card in your HP Pavilion dv6000.

  1. Lay the laptop on a flat surface, battery side up.
    • Lay the laptop on a flat surface, battery side up.

    • Remove the two screws securing the RAM shield to the lower case.

    • The screws will remain captive within the shield.

    • Lift and remove the RAM shield up from the lower case.

    Kommentar hinzufügen

  2. Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.
    • Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.

    • Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.

    Kommentar hinzufügen

    • Remove the two 3.7 mm Phillips screws securing the wireless card to the motherboard.

    • Upon removing the Phillips screws that secures the wireless card to the motherboard, the wireless card board should pop up from its top side.

    • Grasp the wireless card and pull it straight out of its socket on the motherboard.

    Kommentar hinzufügen

    • Wireless card remains.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

4 weitere Nutzer haben diese Anleitung absolviert.

Ben Hirsch

Mitglied seit 05.10.2010

3.622 Reputation

10 Anleitungen geschrieben

Team

Cal Poly, Team 21-33, Regan Fall 2010 Mitglied von Cal Poly, Team 21-33, Regan Fall 2010

CPSU-REGAN-F10S21G33

4 Mitglieder

10 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 5

Letzte 7 Tage: 18

Letzte 30 Tage: 44

Insgesamt: 25,330