Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This guide will display how to remove and install the back panel of the HTC Wizard 200.
Was du brauchst
-
-
To expose the battery, remove the outer case with your fingernail.
-
Remove the battery by pulling the black tab.
-
-
-
Use a spudger to begin removal of the camera cover by inserting the flat end into the two notches and gently pry them up one at a time.
-
-
-
In diesem Schritt verwendetes Werkzeug:T5 Torx Screwdriver$5.49
-
Use a T5 Torx screwdriver to remove four 6mm screws that secure the back panel to the main body.
-
-
-
Insert the flat end of a spudger into the crack between the front and rear cover.
-
Once you have enough of a gap to fit a plastic opening tool into it, use the opening tool to release the clips.
-
-
-
Use the plastic opening tool to continue releasing the clips until you have worked your way around the edge.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.