Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
Is your hair dryer only blowing cold air? You most likely need a new heating element. Use this guide if you are looking to remove and replace a heating element for any standard electric hair dryer. You will save money and learn more about your handheld dryer.
Was du brauchst
-
-
Remove the black air concentrating nozzle by gently twisting and pulling the nozzle.
-
-
-
Using a screwdriver, remove the screw located underneath the air concentrating nozzle. This screw attaches the hair dryer body to the hair dryer grating.
-
-
-
Detach the hair dryer grating from the body by gently twisting the grating from side to side.
-
-
-
-
Locate the screws on the handle of dryer and remove them with a Phillips head screwdriver.
-
-
-
Remove the heat-element housing by sliding it off of the dryer in the direction away from the handle.
-
Slightly twist the casing if needed.
-
-
-
Isolate the heating element. Use a desoldering wick and soldering iron to desolder the wires. Refer to this soldering page for more information on soldering.
-
To reassemble your device, follow these instructions in reverse order. Make sure wiring is enclosed in body of hair dryer and heating element casing is attached properly before screwing it closed.
To reassemble your device, follow these instructions in reverse order. Make sure wiring is enclosed in body of hair dryer and heating element casing is attached properly before screwing it closed.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
8 weitere Nutzer:innen haben diese Anleitung absolviert.