Repariere deine Sachen Community Store

Hand-Held Blender Motor Replacement

Einleitung

The fix is needed when the motor is worn out and overheats when used. To replace the old motor for a new one a Philips screwdriver (2mm), Tri-head screwdriver (2mm) and a soldering iron are needed. Also, you will need a new motor.

Was du brauchst

  1. Hand-Held Blender Motor Replacement, Motor: Schritt 1, Bild 1 von 1

    • Place the product on a clean and empty surface.

    Bearbeiten

  2. Hand-Held Blender Motor Replacement: Schritt 2, Bild 1 von 1

    • Twist the attachment with the blades from the base of the blender.

    Bearbeiten

  3. Hand-Held Blender Motor Replacement: Schritt 3, Bild 1 von 1

    • Unscrew the Tri-point screw (2mm) on the top to disassemble the top part of the casing.

    Bearbeiten

  5. Hand-Held Blender Motor Replacement: Schritt 4, Bild 1 von 1

    • Unscrew the Phillips (2mm) connecting the middle part of the casing with the bottom part.

    Bearbeiten

  6. Hand-Held Blender Motor Replacement: Schritt 5, Bild 1 von 1

    • Use force to twist the middle part from the bottom part of the casing OR use spudgers to wiggle open the product.

    • This reveals the motor.

    Bearbeiten

  7. Hand-Held Blender Motor Replacement: Schritt 6, Bild 1 von 1

    • Lift the motor out of the casing.

    • Unscrew the Phillips (2mm) to disconnect the motor from the plastic part that transfers the motor rotations to the blade.

    Bearbeiten

  8. Hand-Held Blender Motor Replacement: Schritt 7, Bild 1 von 1

    • With a soldering iron disconnect the wires coming from the motor from the PCB.

    • Refer to this How to Solder and Desolder Connections guide to find more information on proper soldering techniques.

    Bearbeiten
Abschluss

To reassemble your device, follow these instructions in reverse order.

Autor:in

mit 2 anderen Mitwirkenden

Nina Rodenburg

Mitglied seit: 03/08/17

109 Reputation

1 Anleitung geschrieben

Auszeichnungen: 3

Team

Delft University of Technology, Team S1-G7, Flipsen Spring 2017 Mitglied von Delft University of Technology, Team S1-G7, Flipsen Spring 2017

TUD-FLIPSEN-S17S1G7

4 Mitglieder

1 Anleitung geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 2

Letzte 7 Tage: 21

Letzte 30 Tage: 71

Insgesamt: 3,289