Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
The Hot Wheels Race System Controller may become unresponsive due to broken or disconnected wires. Heavy use or dropping can cause these disconnections. These wires may need to be reconnected or replaced. Take care when opening the controller as more wires could break.
Was du brauchst
-
-
Remove the six screws located on the back of the controller using a JIS #1 screwdriver.
-
-
-
-
Pop the front of the controller casing from the back and carefully lay the controller out with circuits exposed.
-
-
-
Check all wires for disconnections. They are color coated red, black, orange, and yellow. If wires are disconnected they can easily be reinserted as shown in photos.
-
Some wires may require soldering which can be done with a soldering iron. The wire marked in red may need to be soldered but can sometimes be reattached.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Appalachian State University, Team S1-G2, Menagarishvili Fall 2018 Mitglied von Appalachian State University, Team S1-G2, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S1G2
2 Mitglieder
6 Anleitungen geschrieben
