Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove either of the two 0.2 mm axle screws by using a hex bit 4.0 by turning clockwise.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Slide off the plastic side panel.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a hex bit 4.0 to screw back in the 0.2 mm screw as tightly as possible by turning clockwise.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Flip over the scooter and use the hex bit 4.0 to remove the other 0.2 mm screw.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Slide off the other plastic side panel.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
On the same side you removed the screw, use the bit extender to push down on the axle inside the wheel.
-
2 Kommentare
Where can you get replacement rubber for the front and rear wheels?