Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Be sure that the bucket or pot is big enough to fit the vacuum that will be used for this procedure
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Insert the vacuum into the hole at the bottom of the bucket to be sure it fits
-
If the hole is too small and the vacuum cannot fit within the hole, go back to step one and attempt to enlarge the hole
-
If the hole appears to be too large, one may want to consider going back to step one with a new bucket
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Be sure to wipe down the area that will be worked on with a dry cotton rag
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Place the bucket over the dent that needs to be fixed
-
Start by lightly taping down the bucket with painters tape - this allows the bucket to be held up and allow the rest of the tapping easier to do
-
Go over the edges of the bucket with duct tape until you are sure that it is airtight onto the car
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Place the vacuum into the hole at the bottom of the bucket
-
At this point be sure to allow some time for suction to occur and listen for a small popping noise
-
The popping noise that needs to be listened for is the dent in your car popping out from the suction of the vacuum
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
At times the way the vacuum is positioned can affect the suction
-
If after some time there is no popping noise, adjusting the placement of the vacuum is recommended
-
After adjusting the vacuum allow time for suction again and listen for a popping noise to know when your dent is fixed
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.