Zum Hauptinhalt wechseln
Gemeinsam reparieren - Jetzt registrieren

How to Check a Car's Tire Pressure

Was du brauchst

    1. How to Check a Car's Tire Pressure, How to Check a Car's Tire Pressure: Schritt 1, Bild 1 von 2 How to Check a Car's Tire Pressure, How to Check a Car's Tire Pressure: Schritt 1, Bild 2 von 2
      • Your car's tire pressure information is likely located inside the car door frame toward the bottom.

      • You can also look up this information in your vehicle's owner's manual.

      • Do not refer to the tire pressure information printed on the tire itself! This displays the maximum tire pressure allowed, rather than the recommended amount.

      Frag FixBot

      Kommentar hinzufügen

    2. How to Check a Car's Tire Pressure: Schritt 2, Bild 1 von 3 How to Check a Car's Tire Pressure: Schritt 2, Bild 2 von 3 How to Check a Car's Tire Pressure: Schritt 2, Bild 3 von 3
      • Each tire has a valve stem located on the outer part of the wheel that sticks out.

      • Remove the cap by unscrewing it counter-clockwise and set it off to the side.

      • The cap is very small, so be sure to keep track of it!

      Frag FixBot

      Kommentar hinzufügen

    3. How to Check a Car's Tire Pressure: Schritt 3, Bild 1 von 2 How to Check a Car's Tire Pressure: Schritt 3, Bild 2 von 2
      • Place the stem of the tire pressure gauge onto the tire's valve stem and push on it with a decent amount of force.

      • You'll hear a brief hissing noise as the valve stem quickly opens and closes. If the noise continues, you likely aren't pressing down hard enough.

      • After a second or two, remove the tire pressure gauge. Again, you'll hear a brief hissing noise.

      Frag FixBot

      Kommentar hinzufügen

    4. How to Check a Car's Tire Pressure: Schritt 4, Bild 1 von 2 How to Check a Car's Tire Pressure: Schritt 4, Bild 2 von 2
      • Check the gauge to see what the tire pressure is. If it's low, add air to the tire until the gauge reads the proper tire pressure.

      • To reset the gauge to zero, press down on the gauge's bleeder valve.

      Frag FixBot

      Kommentar hinzufügen

Ziellinie

Rückgängig: Ich habe diese Anleitung nicht absolviert.

4 weitere Personen haben diese Anleitung absolviert.

Craig Lloyd

Mitglied seit: 02/10/16

43.097 Reputation

82 Anleitungen geschrieben

0 Kommentare zur Anleitung

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 29

Letzte 7 Tage: 218

Letzte 30 Tage: 737

Insgesamt: 4,842