Einleitung
A sticking deadbolt is a common nuisance for homeowners. It can be caused by debris, weather, and general wear and tear. This guide will instruct users how to repair a sticking deadbolt. Fortunately, this is an intermediate fix and the estimated time to complete this repair is thirty to forty-five minutes.
Was du brauchst
-
-
Use a Phillips screwdriver to remove both of the ¾-inch screws from the strike plate.
-
-
-
After all four screws have been taken out, slide the latch of the deadbolt out of the door frame.
-
-
-
Spray GumOut parts cleaner at an angle into the latch of the deadbolt.
-
Use a rag to clean and dry off latch.
-
-
-
-
Insert dry powdered graphite into the key cylinder of the deadbolt.
-
Place the key into the cylinder to lubricate and clean the chamber.
-
-
-
Apply the dry powdered graphite to the latch of the deadbolt.
-
Use a rag to remove excess dry powdered graphite from the latch.
-
-
-
Take the lock cylinder and the 2.5 inch mounting screws and insert them through the latch of the deadbolt.
-
Then mount the key cylinder on the screws.
-
Use a Phillips screwdriver to tighten the 2.5 inch mounting screws and secure the deadbolt to the frame.
-
-
-
Use a Phillips screwdriver to screw in both of the ¾-inch screws back into the strike plate.
-
After following this fast fix guide, the sticking deadbolt should be fixed.
After following this fast fix guide, the sticking deadbolt should be fixed.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
5 weitere Nutzer:innen haben diese Anleitung absolviert.
Team
Texas Tech, Team 22-5, Rauch Spring 2016 Mitglied von Texas Tech, Team 22-5, Rauch Spring 2016
TTU-RAUCH-S16S22G5
3 Mitglieder
1 Anleitung geschrieben
