Einleitung
Use this guide to replace a T molding. A T molding is a transition strip used to connect two floorings at the same height.
A loose/ broken T molding can become a hazard as it might cause someone to trip over. Dirt can also add up under the transition strip, making it difficult to clean.
Step 2 of this guide requires measuring and cutting the T molding. Make sure to perform step 1 before purchasing your new T molding so that the place of purchase can cut it for free.
Was du brauchst
-
-
-
Measure the exact width of the doorway using a tape measure.
Frag FixBot
-
-
-
Mark the T molding based on the doorway measure.
-
Cut the T molding using a sharp saw (table saw).
-
If you don't have access to a sharp saw, cut the T molding using a jigsaw and use sanding paper to soften the end.
-
-
-
-
Use a utility knife to remove all the glue or any material used to keep the old T molding in place.
-
Clean up the area thoroughly.
-
-
-
Insert the T molding into the gap.
-
Press the T molding firmly onto the ground.
-
-
-
Tape the T molding onto the floor.
-
Wait 24 hours for the glue to dry.
-
Remove the tapes.
-
-
To reassemble your device, follow these instructions in reverse order.
Team
York University, Team S1-G19, Melo-Thaiss Summer 2021 Mitglied von York University, Team S1-G19, Melo-Thaiss Summer 2021
YORK-MELO-THAISS-SU21S1G19
1 Mitglied
2 Anleitungen geschrieben
