Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Unplug the computer from the power supply before disassembly.
-
Wait 5 minutes after the device has been powered off.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Using a Phillips #1 screwdriver, remove two screws that would grant access to inner components of your computer.
-
Remove the side panel of the computer tower to access the inner components. Slide the panel then lift it to safely remove it.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Using the Phillips #1 screwdriver, remove the screw holding the graphics card (GPU) onto the motherboard.
-
Disconnect any power cables that may be attached to your graphics card.
-
Carefully slide the graphics card out from its slot.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the CMOS Battery using a plastic opening tool.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Wait 5 minutes to allow enough time for the power to cycle through.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Insert battery back into position with the flat side facing upwards.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.