Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This guide will give an in-depth demonstration of how to tune single pivot caliper brakes on a bicycle in addition to our project show tips and tricks with important cautions during disassembly.
Was du brauchst
-
-
Set bike up on bike stand or have someone hold onto the bike, keeping it balanced.
-
Pull on brake levers so that the brakes pads are touching the edge of the rim.
-
-
-
Using a 10 mm wrench, back out of the barrel adjuster on the brake calipers 2-3 turns.
-
With the same 10 mm wrench, loosen the pinch bolt at the bottom of brake caliper to release the brake wire.
-
-
-
-
With the 10 mm wrench, loosen the bolt connecting the brake caliper to the frame of the bicycle.
-
Adjust the brake caliper so that it is centered with the tire and rim. Tighten bolt back up when finished.
-
-
-
Take the 10 mm wrench and loosen the bolt on the back side of the brake pad.
-
Adjust the brake pads position on the rim by sliding it up and down along the surface of the rim until it is centered.
-
When finished, tighten the bolt for the brake pad back up to hold its position.
-
-
-
Pull on the the brake lever to adjust the pad clearance from the brake line.
-
Tighten the barrel adjuster at the brake caliper.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Ein Kommentar
How do u fix the mounting bolt to the front caliper that connects brake to bike that bolt where do I get one