Zum Hauptinhalt wechseln

Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.

Was du brauchst

  1. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 1, Bild 1 von 3 : Schritt 1, Bild 2 von 3 : Schritt 1, Bild 3 von 3
    • Open the boot, turn over the floor and retrieve the jack crank and the tire iron.

    • Open the compartment where the jack is located.

    • Using the jack crank, turn the jack axle counter clockwise to unsecure it from the compartment and pull it out.

  2. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 2, Bild 1 von 2 : Schritt 2, Bild 2 von 2
    • There are 4 u-shaped jack supports underneath the car, located next to each wheel.

    • Turn the jack axle by hand until the support slot of the jack can be placed on the support.

    • Only use the emergency jack on the jack supports.

    • Make sure the car is on a hard level surface.

    • Make sure the jack has at least 51mm load free displacement from its starting position.

  3. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 3, Bild 1 von 2 : Schritt 3, Bild 2 von 2
    • Make sure the handbrake is on, and the gear is in reverse for manual or park for an automatic transmission car.

    • Make sure no people are in the car when the car is jacked up.

    • Place the jack crank on the jack axle, and using the tire iron, turn clockwise.

    • Stop cranking when the wheel is high enough from the ground to be replaced.

    • Do not go underneath the car while it is jacked up with the emergency jack.

Ziellinie

Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.

knipwim

Mitglied seit: 09/01/18

8.527 Reputation

30 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 11

Letzte 7 Tage: 73

Letzte 30 Tage: 288

Insgesamt: 13,213