Zum Hauptinhalt wechseln

Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.

Was du brauchst

  1. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 1, Bild 1 von 2 : Schritt 1, Bild 2 von 2
    • Use the 0.8 Sim driver bit to remove the SIM tray by inserting it into the hole on the side of the device.

    • Once the hole is pressed in firm, the SIM tray will pop out. This allows you to grab it, and extract it from the device.

  2. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 2, Bild 1 von 2 : Schritt 2, Bild 2 von 2
    • Make a thumbs-up and use it to grip the plastic opening tool with the flat end pointing in the direction of your thumb.

    • Place the flat end of the opening tool slightly inside the charging port and place your thumb on the back of the phone.

    • Press into the phone with your thumb while pulling the opening tool back with your fist to begin prying the back off.

  3. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 3, Bild 1 von 2 : Schritt 3, Bild 2 von 2
    • Slide the flat end of the spudger along the edge of the device, prying off the back cover.

    • Carefully remove the back cover. This may be difficult due to glue on the inside.

  4. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 4, Bild 1 von 2 : Schritt 4, Bild 2 von 2
    • Use a Phillips screwdriver to remove 20 screws around the perimeter of the phone.

  5. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 5, Bild 1 von 3 : Schritt 5, Bild 2 von 3 : Schritt 5, Bild 3 von 3
    • First, carefully remove the speaker assembly at the bottom of the phone.

    • Use a spudger to pry up the antenna assembly located along the top right-hand side of the phone.

    • Use a spudger to pull off the top-left tab.

    • Finally, carefully remove the entire back plate assembly from the motherboard.

  6. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 6, Bild 1 von 1
    • Place the tip of your spudger or opening too under the edge of the connector, and pry the battery connector straight up from its socket.

  7. Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!

    : Schritt 7, Bild 1 von 2 : Schritt 7, Bild 2 von 2
    • Use the spudger to pry the lithium battery away from battery compartment.

    • Insert new battery and connect.

Ziellinie

5 weitere Nutzer:innen haben diese Anleitung absolviert.

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 1

Letzte 7 Tage: 7

Letzte 30 Tage: 10

Insgesamt: 4,503