Zum Hauptinhalt wechseln

Huawei P10 Lite Battery Disconnection

Grundständige Anleitung
Dies ist eine grundständige Anleitung, die nur als Teil einer anderen Anleitung verwendet werden sollte.

Was du brauchst

  1. Huawei P10 Lite Battery Disconnection, Back cover: Schritt 1, Bild 1 von 3 Huawei P10 Lite Battery Disconnection, Back cover: Schritt 1, Bild 2 von 3 Huawei P10 Lite Battery Disconnection, Back cover: Schritt 1, Bild 3 von 3
    • Insert the tip of an opening pick between the back cover and the mid frame and slide it around the phone, to cut the adhesive.

    • Using a suction handle to lift the back cover may help to get an initial gap for the opening pick to put in.

    • If the adhesive is hard to cut, use an iOpener to loosen it.

  2. Huawei P10 Lite Battery Disconnection: Schritt 2, Bild 1 von 3 Huawei P10 Lite Battery Disconnection: Schritt 2, Bild 2 von 3 Huawei P10 Lite Battery Disconnection: Schritt 2, Bild 3 von 3
    • After you cut the adhesive on every edge, twist your opening pick, to separate the rear cover from the phone.

    • Flip the rear cover over to the right side of the phone.

  3. Huawei P10 Lite Battery Disconnection: Schritt 3, Bild 1 von 2 Huawei P10 Lite Battery Disconnection: Schritt 3, Bild 2 von 2
    • Use a pair of tweezers to remove the sticker.

    • Remove the two Phillips #00 screws.

    • Remove the four 2.5 mm Phillips #00 screws.

  4. Huawei P10 Lite Battery Disconnection: Schritt 4, Bild 1 von 2 Huawei P10 Lite Battery Disconnection: Schritt 4, Bild 2 von 2
    • Use tweezers to remove the mainboard shield.

    • Use the flat end of a spudger to disconnect the finger print sensor flex cable.

    • When reassembling apply new adhesive where it is necessary.

  5. Huawei P10 Lite Battery Disconnection, Battery Disconnection: Schritt 5, Bild 1 von 3 Huawei P10 Lite Battery Disconnection, Battery Disconnection: Schritt 5, Bild 2 von 3 Huawei P10 Lite Battery Disconnection, Battery Disconnection: Schritt 5, Bild 3 von 3
    • Remove the Phillips screw holding the battery connector plate in place.

    • Remove the battery connector plate.

    • Use the flat end of a spudger to disconnect the battery flex cable.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Dominik Schnabelrauch

Mitglied seit: 11/23/16

201.012 Reputation

682 Anleitungen geschrieben

Team

iFixit Mitglied von iFixit

Staff

136 Mitglieder

16.560 Anleitungen geschrieben

0 Kommentare

Kommentar hinzufügen

Seitenaufrufe:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 158