Einleitung

Use this guide if your Huawei Union will not charge when plugged into a charger or begins losing charge faster than previously observed.

Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.
  • Wedge your thumb nail, or the flat end of a spudger, into the bottom left corner and pry off.

Kommentar hinzufügen

Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.
  • Use the flat end of a spudger, or fingernail, to lift up the battery and pull out.

Kommentar hinzufügen

  • Remove the thirteen 3mm Phillips #00 screws from the back panel.

Kommentar hinzufügen

  • Use the flat end of a spudger to pry off the back panel.

Kommentar hinzufügen

  • Remove a single 3mm Phillips #00 screw from the motherboard.

Kommentar hinzufügen

  • Using the flat end of a spudger to disconnect the motherboard ribbon cable.

Kommentar hinzufügen

  • Firmly hold the second ribbon cable's plastic film cover and pull up to disconnect.

Kommentar hinzufügen

  • Wedge the flat end of a spudger underneath the motherboard and pry upwards to separate it from the frame.

Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Brittany Achor

Mitglied seit 14.02.2018

651 Reputation

6 Anleitungen geschrieben

Team

USF Tampa, Team S1-G1, Nance Spring 2018 Mitglied von USF Tampa, Team S1-G1, Nance Spring 2018

USFT-NANCE-S18S1G1

4 Mitglieder

6 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 5

Insgesamt: 68