Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Find the edge of the control unit and get a very fine flathead screw driver (or a plastic pry tool which would do less damage)
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Wedge the tool in the corner and start sliding it to the left.
-
As you do this slowely twist the screw driver back and forth to release the clips.
-
Try not to let the tool slip into the control unit as this may damage the circuit board inside.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Repeat step 2 and the control unit should open as seen in the image.
-
Remove the plastic sleeves and you will be left with just the circuit board (see second image).
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
It is quickly seen that one of the wires has broken away from the circuit board (see image)
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Once the wire is found a steady hand and a fine tipped soldering iron should be used to reattach the wire.
-
Ensure that you do not head to circuit board for too long as it may cause damage (be as quick as possible!)
-
After this, the circuit board and wires should be replaced as they were before. Press the plastic cover halves together and it should click back into place.
-
And they are fixed!
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
4 weitere Nutzer:innen haben diese Anleitung absolviert.