Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Was du brauchst
-
-
Flip the projector right-side up and turn it so that the back ports are facing you.
-
Remove the 7mm metallic hex screws using the flat-head screwdriver.
-
Remove the two black 10mm screws using the T10 Torx screwdriver head. The screws are located at the center of the back panel.
-
-
-
Flip the projector over.
-
Remove the two 77mm screws that are located nearest to the back panel ports. Use the T10 Torx screwdriver head.
-
Next, remove the two 10mm screws located near the lens side with the T10 Torx screwdriver head.
-
Flip the projector back over.
-
-
-
-
Unplug the speaker wire from the circuit board by simultaneously squeezing the sides and pulling.
-
Pull on the brown tabs located at the sides of the white plastic ribbon holder and pull the ribbon out.
-
Pull the top cover back.
-
-
-
Remove the five 5mm screws located throughout the motherboard with the screwdriver. Use the T10 Torx screwdriver head.
-
Pull up on each metal tab located at the rear of the projector. There are 5 tabs.
-
-
-
Remove the three gold ribbons by flipping up the black taps that hold the ribbon in place.
-
Pull the ribbons out carefully and place them under the main board.
-
Carefully lift the entire main board up.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 13-17, Regan Winter 2014 Mitglied von Cal Poly, Team 13-17, Regan Winter 2014
CPSU-REGAN-W14S13G17
6 Mitglieder
5 Anleitungen geschrieben
