Einleitung
If your JBL Clip 2's built in AUX cord is not playing music from your music device there may be an issue with the cord itself. The device will be taken apart and the audio AUX cord will be removed and replaced.
Was du brauchst
-
-
Begin by removing the front cap of the JBL Clip 2 by using the blue plastic opening tool to get in between the creases.
-
-
-
There will be six 3 mm T8 screws under the cap, remove these six screws. Save
-
If you are not trying to replace the speaker please ignore the two middle 3 mm T8 screws during this procedure.
-
-
-
-
To completely remove the top portion, disconnect the speaker from the motherboard using the blue plastic opening tool.
-
-
-
There will be four 3 mm T8 screws holding the motherboard in place, remove these four screws.
-
-
-
Disconnect the three solder points connecting the AUX cord to the motherboard.
-
Remove the AUX cord.
for the jbl clip 2 where do you buy the aux replacement cord?
have you found where it sells?
I used these guides to help me get the Clip 2 apart and found that my problem was a bad solder joint at the speaker connector. Apparently the manufacturer noticed it too because there was a (grease pencil) circle around the holes on the bottom side of the motherboard and their fix was to hot glue the connector to the board. I re-soldered the pins and it works perfectly.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
3 weitere Nutzer:innen haben diese Anleitung absolviert.