Einleitung
This guide give instructions on how to locate the keypad for removal and/or repair.
Werkzeuge
Ersatzteile
Kein Ersatzteil erforderlich.
-
-
Flip over the phone and then slide down the back cover with your thumb.
-
-
-
Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.
-
-
-
Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.
-
-
-
Open the phone and turn it on its side.
-
Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.
-
-
-
Using your hand, gently pull of the back panel from the bottom half of the phone.
-
-
-
Close the phone and place it on a flat surface.
-
Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing.
-
-
-
On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.
-
Using a plastic opening tool, slowly detach the ribbon cable connector, then pull the motherboard away from the frame.
-
-
-
Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein weiterer Nutzer hat diese Anleitung absolviert.