Werkzeuge

Kein Werkzeug erforderlich.

  1. Remove both 8.0 mm Phillips #1 screws, one for each wheel.
    • Remove both 8.0 mm Phillips #1 screws, one for each wheel.

  2. Remove the wheels by pulling them away from the RC car.
    • Remove the wheels by pulling them away from the RC car.

  3. Kostenloser Versand für alle Bestellungen über 100,00 $ oder mit einem Pro Tech Toolkit!

    Schau dich im Store um
  4. Make note of where each driving gear cover is placed. They only go in one way.
    • Make note of where each driving gear cover is placed. They only go in one way.

    • Remove the eight 8.0mm Phillips #00 screws, two screws for each wheel.

  5. Pry open the two gear covers on both sides.
    • Pry open the two gear covers on both sides.

  6. Pull the driving gears off the axles by sliding them off the axles and exposing both axles.
    • Pull the driving gears off the axles by sliding them off the axles and exposing both axles.

  7. Slide both axles from the internal axles guides within the car.
    • Slide both axles from the internal axles guides within the car.

    • Reverse the steps to replace the axles.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Rusbell Gonzalez

Mitglied seit: 17.09.2014

219 Reputation

5 Anleitungen geschrieben

Team

USF Tampa, Team 1-2, Hickman Fall 2014 Mitglied von USF Tampa, Team 1-2, Hickman Fall 2014

USFT-HICKMAN-F14S1G2

3 Mitglieder

7 Anleitungen geschrieben

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 2

Insgesamt: 136