Kindle Paperwhite 1st Generation Case Replacement

Einleitung

The case of your Kindle Paperwhite gets a lot of abuse from everyday life. Replace a cracked or a scratched case to restore that fresh out-of-the-box feeling.

Was du brauchst

Schritt 1 Case

Kindle Paperwhite 1st Generation Case Replacement, Case: Schritt 1, Bild 1 von 2

Kindle Paperwhite 1st Generation Case Replacement, Case: Schritt 1, Bild 2 von 2

Using a spudger or plastic opening tool, gently pry the bezel from the screen. It is easier to start in the corners and work your way around the bezel.
Do not insert the spudger too far under the bezel; it could easily damage the screen.

Bearbeiten

I found it easier to start this step off with one of the Opening Picks found in the iOpener pack.

NathanF - 27. Dez 2017 Antwort

The glue on bezel started to peel the sticky back protective layer off the screen for me - managed to smooth it back down, although now have an unsightly crease. I would try to hold the screen down when you pull the bezel off to stop damaging the screen.

Callum Rogers - 27. Aug 2021 Antwort

This step is most time consuming. Take you time and try not to scratch the bezel :)

Oleksii - 1. Sep 2021 Antwort

Couldn't get the plastic spudger under the edge of the bezel. A right-angle X-Acto blade was a satisfactory tool here.

dbrick - 29. Mai 2022 Antwort

The glue was VERY difficult...I used a trick, from taking apart phones, and used a hair drier to loosen up the glue...worked like a charm.

billkaris - 9. Aug 2022 Antwort

Schritt 2

Kindle Paperwhite 1st Generation Case Replacement: Schritt 2, Bild 3 von 3

Remove the eleven 3.0 mm Phillips screws surrounding the midframe.
At the top of the display, a strip of black tape covers one screw.

Bearbeiten

On 3G version you will not have the top middle screw.

BJones - 21. Mai 2016 Antwort

Hello, the original battery is 1420m Ah and 3.7VDC, but the buttery you offer to sell is 1600mAh, is it right? there is no problem with different mAh? mi kindle is the amazon kindle 1est generation

Paula Ponce de Leon - 9. Nov 2020 Antwort

Schritt 3

Lift the midframe out of the case.
If the midframe is stuck, slide it to the left first, and then lift it out.

Bearbeiten

There are clips in the bottom of the case helping hold the midframe in. Lift the top of the midframe up enough to clear the black back piece and then slide up and out.

BJones - 21. Mai 2016 Antwort