Zum Hauptinhalt wechseln

Einleitung

Removing and replacing the LCD and LCD casing.

Ersatzteile

Keine Ersatzteile angegeben.

  1. Use your finger tip to slide battery cover door away from the center of the camera.
    • Use your finger tip to slide battery cover door away from the center of the camera.

    • The battery door should spring open.

    • If this does not happen, gently open the door lifting from the outer bottom side of the camera.

  2. Remove the old batteries.
    • Remove the old batteries.

  3. Remove 7 screws from the outer case with a Phillips #00. All screws are 4.45mm. There are 2 screws on the port side.
    • Remove 7 screws from the outer case with a Phillips #00.

    • All screws are 4.45mm.

    • There are 2 screws on the port side.

    • There are 2 screws on starboard side.

    • There are 3 screws on the bottom.

  4. Make sure the battery cap is "up". Pull the outer case off with your hands. Pull the outer case off with your hands.
    • Make sure the battery cap is "up".

    • Pull the outer case off with your hands.

  5. MacBook Akku Fix Kits

    Ab $69.99

    Buy Now

    MacBook Akku Fix Kits

    Ab $69.99

    Buy Now
  6. The LCD Screen is hinged at the bottom.
    • The LCD Screen is hinged at the bottom.

    • Put your thumb in the upper right corner of the LCD Screen.

    • Pull the LCD screen out of it's outer case with your thumb.

  7. Remove the screw underneath LCD screen with the Phillips #00. The screw measures 4.1mm in length.
    • Remove the screw underneath LCD screen with the Phillips #00. The screw measures 4.1mm in length.

  8. Desolder the two points. One on the port side.
    • Desolder the two points.

    • One on the port side.

    • One on the bottom.

  9. After desoldering the LCD casing, just use your fingers to carefully remove it.
    • After desoldering the LCD casing, just use your fingers to carefully remove it.

  10. Flip up the black tab on the bottom of the LCD Screen with a fingertip.
    • Flip up the black tab on the bottom of the LCD Screen with a fingertip.

  11. Remove the LCD ribbon cable from inside the black tab.
    • Remove the LCD ribbon cable from inside the black tab.

Abschluss

To reassemble your device, follow these instructions in reverse order.

6 weitere Nutzer haben diese Anleitung absolviert.

Taggart Ashby

Mitglied seit: 15.04.2010

315 Reputation

4 Anleitungen geschrieben

Team

Cal Poly, Team 26-19, Regan Spring 2010 Mitglied von Cal Poly, Team 26-19, Regan Spring 2010

CPSU-REGAN-S10S26G19

4 Mitglieder

7 Anleitungen geschrieben

Thank you... i fixed my old camera lcd.

anthoxman - Antwort

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 1

Letzte 30 Tage: 7

Insgesamt: 4,780