Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
This will teach you how to remove the capacitor in your Kodak EasyShare LS743.
Was du brauchst
-
-
Slide the orange latch sideways to eject the battery.
-
Remove the battery from the battery slot.
-
-
-
Using a Phillips #00 screwdriver, remove two 5.39 mm screws next to the battery slot.
-
Remove the metal piece holding down the lanyard, then remove the lanyard.
-
-
-
Using a Phillips #00 screwdriver, remove seven screws located on the outside case of the camera.
-
One 6.25 mm screw is located on the top right corner, right to the "OK" button.
-
Four 4.45 mm screws are on the bottom of the camera.
-
Two 2.95 mm screws are on the left side of the camera, above the USB port.
-
-
-
-
Carefully remove the rear camera casing.
-
Carefully remove the front camera casing.
-
-
-
Connect the two capacitor wires briefly with a pair of metal tweezers to discharge it. You may see a small spark.
-
Remove 8 screws.
-
2 screws in the front (2X 4.31mm).
-
2 screws on the bottom (2X3.30MM).
-
4 screws in the back (3x 3.33mm, and 1x 4.34mm).
-
-
-
Pull the black latch outward slightly to release the flex cable.
-
Carefully disconnect the orange flex cable.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Cal Poly, Team 2-8, Johann Summer 2010 Mitglied von Cal Poly, Team 2-8, Johann Summer 2010
CPSU-JOHANN-R10S2G8
5 Mitglieder
16 Anleitungen geschrieben
