Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the two screws from the right hand side
-
Remove the two screws from the left hand side
-
Remove the three screws from the bottom.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Open the battery compartment and start carefully to separate the front and back half of the camera. On this camera the front half will come of first.
-
In the top left corner is one screw that will have to be removed. It holds the back cover to the body of the camera.
-
Once that screw is removed, the camera separates easy.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Fold the LCD from the top downward. DO NOT try to remove the LCD, it is still attached. Obviously this camera has had water damage.
-
Remove the Kapton tape from the top of the camera.
-
you will have to de-solder the battery frame on one point.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Remove the tape
-
Remove the single screw.
-
You can disconnect the ribbon cable, by carefully pulling on the end. I opted to leave it connected to minimize the risk of tearing the fragile cable. It is possible to just move the frame out of the way.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the LCD frame slightly up and fold the black clip gently to the back.
-
This will loosen the ribbon cable and lets your remove the LCD.
-
Insert the ribbon cable of the new LCD. there will be a solid white stripe on the cable. Insert the cable as shown, close the connector.
-