Was du brauchst
-
-
Insert the plastic opener into the slot at the top of the device.
-
Apply gentle pressure with the plastic tool to pop the back case off.
-
-
-
Use a screwdriver and corresponding bit to remove the six 2mm screws that are located along the edge of the rear case. Set the screws aside.
-
-
-
Use a screwdriver and corresponding bit to remove the two 3mm screws that attach the motherboard to the front case. Set the screws aside
-
-
-
Rotate the phone 180 degrees and use the plastic opener to lift the metal piece that covers the ribbon cable.
-
-
-
Use tweezers to disconnect the two cables that attach the motherboard to the case.
-
-
-
-
Use a screwdriver and corresponding bit to remove the four 1mm screws. Set the screws aside.
-
-
-
Pull the ribbon cable through the slit in the keyboard case to separate it from the sliding mechanism.
There’s a tricky part not visible in this photo. The ribbon cable may be attached with a little bit of double sticky tape. Pry it up carefully with a spudger or other plastic tool.
-
-
-
Use a screwdriver and corresponding bit to remove the four 3mm screws. Set the screws aside.
-
-
-
Use the plastic opener to pry open the front of the phone.
-
Slip the ribbon cable through the slit to fully separate the two pieces.
-
-
-
Use a screwdriver and corresponding bit to remove the two 1mm screws. Set the screws aside.
-
-
-
Use the spudger to pry the metal piece loose.
-
Remove the metal piece along with the two ribbon cables.
Seems to be missing a step here: how to remove the third ribbon cable (short one on lower right corner of photo)? Mine is under black plastic cover and blue plastic film. I had to move to Step 19 to take the black plastic piece off.
-
-
-
Flip the front of the phone over and the old option buttons will fall out.
-
Insert new option buttons.
-
-
-
Use a tool to pry open the LCD display. Remove the display and the circuit board that it's connected to.
-
-
-
Remove the plastic piece from the circuit board by unlocking the switch on the plastic piece with a pair of tweezers.
-
-
-
Pull the LCD display away from the circuit board.
Pick up the little plastic retainer bar, or the ribbon cable will resist coming out.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Rückgängig: Ich habe diese Anleitung nicht absolviert.
Ein:e weitere:r Nutzer:in hat diese Anleitung absolviert.
Team
Clemson, Team 13-1, Benson Fall 2013 Mitglied von Clemson, Team 13-1, Benson Fall 2013
CLEM-BENSON-F13S13G1
3 Mitglieder
16 Anleitungen geschrieben
