Einleitung

This guide will show you how to replace a worn out, scratched, or damaged internal keyboard on the LG LX160 cell phone. To begin this guide, complete steps 1 to 10 of the tear down guide

Ersatzteile

Kein Ersatzteil erforderlich.

  1. Place the phone on a flat surface that the back is facing you. Remove the back panel by placing your thumb on the LG logo and sliding the panel across the length of the phone until it is removed.
    • Place the phone on a flat surface that the back is facing you. Remove the back panel by placing your thumb on the LG logo and sliding the panel across the length of the phone until it is removed.

    Kommentar hinzufügen

  2. Once the panel is removed, you are looking directly at the battery. It is the black rectangle in the middle of the phone.  You can remove the battery by sliding a finger into the notch where the LG logo was on the panel and lifting up the battery.
    • Once the panel is removed, you are looking directly at the battery. It is the black rectangle in the middle of the phone. You can remove the battery by sliding a finger into the notch where the LG logo was on the panel and lifting up the battery.

    Kommentar hinzufügen

    • Remove the battery completely from the phone.

    Kommentar hinzufügen

    • Before continuing pull off all the rubber tabs to the headphones, and the power input.

    Kommentar hinzufügen

    • Now turn the phone so that you can see the back where the battery was. Using a screw driver, unscrew the 6 screws holding the back casing together.

    Kommentar hinzufügen

    • At the top of the logic board there is a small rectangle with a white pad on it, use your tweezers and gently grip the neck of the orange wire.

    • Gently pull up on the orange wire until it comes loose. It may take some force so do not be concerned with being overly gentle.

    Kommentar hinzufügen

    • After pulling on the orange wire it should come loose like the image.

    • Be sure that the black chip on the underside of the orange wire is all the way out like in the picture before continuing to the next step.

    Kommentar hinzufügen

    • Now you can remove the logic board from the casing, and set it aside.

    • If you're replacing the logic board insert the board into the phone and attach the phone via the small orange tab

    Kommentar hinzufügen

    • Peel out the keypad in the back of the phone. It is the white flimsy plastic from the bottom.

    Kommentar hinzufügen

    • The keyboard will be separated and may be replaced with a new keyboard.

    Kommentar hinzufügen

Abschluss

To reassemble your device, follow these instructions in reverse order.

Shane Smith

Mitglied seit 14.01.2010

1 Reputation

2 Anleitungen geschrieben

Team

Cal Poly, Team 11-2, Forte Winter 2010 Mitglied von Cal Poly, Team 11-2, Forte Winter 2010

CPSU-FORTE-W10S11G2

5 Mitglieder

10 Anleitungen geschrieben

Kommentar hinzufügen

Statistik anzeigen:

Letzte 24 Stunden: 0

Letzte 7 Tage: 0

Letzte 30 Tage: 0

Insgesamt: 1,401