Diese Version enthält möglicherweise inkorrekte Änderungen. Wechsle zur letzten geprüften Version.
Was du brauchst
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use tweezers to peel the plastic cover off the connector.
-
Use a spudger or your fingernail to pry up the battery straight up from the motherboard.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Lift the battery out of the frame and remove it from the device.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Unscrew the 3mm screw holding down the wireless adapter using a Phillips #00 screwdriver.
-
Slide the adapter out of its connector.
-
Detach the black and gray cables and separate them from the frame of the fan by gently pulling upwards.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Unlatch and remove the cable connecting to the frame of the fan by flipping the thin black tab up.
-
Separate the cable from the frame of the fan.
-
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Loosen the five screws connecting the fan to the motherboard using a Philips #00 head screwdriver.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Gently disconnect the two cables located on right and left side of the fan.
-
Lift the fan up and out and remove it from the device.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Use a Phillips #00 screwdriver to remove the five 4 mm screws below the charging port.
-
Use a Phillips #00 screwdriver to remove the two 3 mm screws.
-
Use a Phillips #00 screwdriver to remove the two 5 mm screws securing a silver plate on the charging port, in the top-right.
-
Remove the silver plate on top of the charging port.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Disconnect all the ribbon wires from the motherboard.
-
All ribbon wires can be disconnected by flipping up the thin black tab at their connection points, and pulling the ribbon out.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Disconnect the black attachment at the top right corner of the motherboard.
-
Insert the SIM eject bit into the small hole on the top and apply a small amount of pressure to release the clip.
-
While maintaining pressure, gently pull on the wire that is connected to it to remove it.
-
-
Dieser Schritt ist noch nicht übersetzt. Hilf mit, ihn zu übersetzen!
-
Gently lift the motherboard out of the computer.
-
Rückgängig: Ich habe diese Anleitung nicht absolviert.
2 weitere Nutzer:innen haben diese Anleitung absolviert.