Zum Hauptinhalt wechseln

Einleitung

Does your Yoga 700 no longer get the battery life that it used to or not turn on without being plugged to an outlet? Your battery may be defective, and this guide will help you remove and replace your battery unit so you'll be able to take your Yoga on the go again.

  1. Flip your device so that the bottom panel is facing up. Remove the eleven 5mm Torx T5 screws from the back panel.
    • Flip your device so that the bottom panel is facing up.

    • Remove the eleven 5mm Torx T5 screws from the back panel.

    Your list of t7 screwdriver costed me to order a wrong one.

    it should be T5 but the ad listed T7!!!!!

    it is frustrating.

    Remy Williams - Antwort

    Mine had T5 as well.

    alan - Antwort

  2. Use a spudger to unclip clips on the front and near the USB ports on each side
    • Use a spudger to unclip clips on the front and near the USB ports on each side

    • Lift the back panel off

    where can I buy the back panel?

    malinthae - Antwort

    The back panel is also held on by a few clips, but a spudger can come in handy here.

    alan - Antwort

    The clips on the sides are between the USB ports on the left side, and just in front of the USB port on the right.

    alan - Antwort

  3. Remove the two 3mm Phillips #1 screws holding the battery to the laptop chassis.
    • Remove the two 3mm Phillips #1 screws holding the battery to the laptop chassis.

    • Disconnect the battery from the IO board by holding the connector by the sides and gently pulling the connector out.

    The left screw is hidden below a tamper-evident sticker.

    alan - Antwort

    There is a plastic channel along the right edge of the battery that has wires running through it to a different board. It works best if the other connector next to the battery connector is unclipped and those wires are taken out of that channel.

    alan - Antwort

  4. Carefully remove the battery from the laptop.
    • Carefully remove the battery from the laptop.

    • Make sure that all wires still connected to the laptop are out of the way and not pulled out with the battery.

    Along the right edge of the battery, there is a channel with wires running to a connector next to the battery connector. It works better to disconnect that connector too and fold the battery to the right.

    alan - Antwort

    Re: the above “fold the battery to the right” comment: If all you’re doing is replacing the touchpad, the “fold over” method works as it keeps the wires in the channel. If you’re replacing the battery or whatever those wires connect to, obviously that won’t work.

    alan - Antwort

Abschluss

To reassemble your device, follow these instructions in reverse order.

7 weitere Nutzer haben diese Anleitung absolviert.

Sean Wong

Mitglied seit: 06.10.2016

859 Reputation

3 Anleitungen geschrieben

Team

Cal Poly, Team 15-6, Livingston Fall 2016 Mitglied von Cal Poly, Team 15-6, Livingston Fall 2016

CPSU-LIVINGSTON-F16S15G6

4 Mitglieder

7 Anleitungen geschrieben

2 Kommentare

Hey

I own lenovo yoga 700 14 inch, it has a motherboard 5b20k41654. For some reason two of mother board ics burnt out

I have got the number of one IC but failed to find the number/code of other. (the IC I am looking for resides near left side of ram slot)

Please let me know if someone can help me finding the right IC or Schematic of yoga 700 motherboard

I'll be very great full

Thanks

muhammad bilal - Antwort

Why do you recommend buying a T7 Torx Screwdriver? I bought it, then re-read your tutorial after I couldn't unscrew the screws, where you said it should be a T5 Torx Screwdriver...

Eric Macaluso - Antwort

Kommentar hinzufügen

Seitenaufrufe:

Letzten 24 Stunden: 0

Letzten 7 Tage: 5

Letzten 30 Tage: 39

Insgesamt: 7,443