Diese Anleitung enthält neuere Änderungen. Wechsel zur neuesten unüberprüften Version.
Einleitung
You will be desoldering and replacing the power connector.
Was du brauchst
-
-
Turn the router over so that all four of its feet are facing upwards.
-
-
-
Remove the rubber inserts inside the the two purple feet located on the router's front case.
-
This may be a challenge, so try the following two methods:
-
Use a plastic opening tool. Insert the flat end of the tool into the seam and slowly pry the rubber feet out.
-
Use a metal spudger. Insert the point of the metal spudger directly into the hole of the rubber feet and pry the insert out.
-
-
-
Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.
-
-
-
-
Squeeze the sides of the router's backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.
-
-
-
Flip the circuit board over and use a Phillips #2 Screwdriver to remove the 6.9mm screw holding the board to the back case.
-
Slide the back cover out and away from the circuit board.
-
-
-
Turn the circuit board over and identify the solder connections you will desolder.
-
The connections for the power connector are shown in red.
-
-
-
Desolder the connection by following iFixit's guide to repairing soldered connections: Wie man Lötverbindungen herstellt und entlötet.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Cal Poly, Team 3-4, Regan Fall 2011 Mitglied von Cal Poly, Team 3-4, Regan Fall 2011
CPSU-REGAN-F11S3G4
4 Mitglieder
12 Anleitungen geschrieben
