Gemeinsam reparieren - Jetzt registrieren

Einleitung

Use this guide to replace a damaged or cracked controller case on your Logitech Gamepad F310. The controller case is what holds your controller together. That is reason to replace controller case.

Follow this guide in order to replace your Logitech Gamepad F310 controller case.

No special tools or skills required.

Was du brauchst

Schritt 1 Case

Logitech Gamepad F310 Case Replacement, Case: Schritt 1, Bild 1 von 2

Logitech Gamepad F310 Case Replacement, Case: Schritt 1, Bild 2 von 2

Use a Phillips #1 screwdriver to remove all seven 3 mm screws that secure the rear case.

Bearbeiten

Frag FixBot

Schritt 2

Press along the seams of the controller and gently pull the front and rear case apart.
If necessary, use an opening tool to help pry the front and rear case apart.
Make sure to open the controller with the front facing down so that the buttons do not fall out.

Bearbeiten

Frag FixBot

Schritt 3

Separate the front and rear case.
There are two side panels on the controller that come apart as well. When putting them back together, they slot into place on the sides of the controller.

Bearbeiten

Frag FixBot

Schritt 4 Case

Logitech Gamepad F310 Case Replacement, Case: Schritt 4, Bild 1 von 2

Logitech Gamepad F310 Case Replacement, Case: Schritt 4, Bild 2 von 2

Use a Phillips #1 screwdriver to remove:
Four 3 mm screws
One 5 mm screw
Remove the central silver screw last.
Gently lift the motherboard off of the back case and slide the cord out of the slot on top.

Bearbeiten

Frag FixBot

Abschluss

You have successfully taken the case off of your controller! Using the new case, follow these steps in reverse order to assemble your fixed controller.

Rückgängig: Ich habe diese Anleitung nicht absolviert.